Expert hvac installation in San Antonio, TX. NATE-certified technicians, quality equipment, and results you can count on.
Replacing your San Antonio, Texas HVAC system with properly sized, high-efficiency equipment can reduce energy costs by 30 to 50 percent while improving comfort in every room. KIC Refrigeration handles equipment selection, ductwork modifications, refrigerant line installation, electrical upgrades, and full commissioning to verify rated SEER and AFUE performance from day one.
San Antonio homeowners and businesses count on reliable hvac installation to maintain comfort and protect indoor air quality. Serving a city of 1,570,314 across Texas, KIC Refrigeration brings the experience and crew depth to handle hvac installation projects of any scale. We begin every job with an honest evaluation and a clear, written estimate.
Our hvac installation technicians in San Antonio, TX are NATE-certified, EPA 608 licensed, and equipped with advanced diagnostic tools. From the initial inspection through final commissioning, we maintain open communication and hold ourselves to the highest standards. That is how KIC Refrigeration has earned the trust of homeowners across Texas.
A clear, step-by-step approach to every hvac installation project we take on.
KIC Refrigeration begins every HVAC installation in San Antonio, TX with a detailed in-home survey and ACCA-compliant Manual J load calculation. We account for your home envelope, duct losses, infiltration, occupancy, and the local TX design temperatures for both heating and cooling seasons.
Based on load calculations and your priorities — efficiency, noise level, budget, zoning — we recommend specific equipment and provide a detailed written proposal covering equipment model numbers, SEER2/AFUE ratings, installation scope, warranty, and total cost.
At your San Antonio property, our team removes the old system, installs the new equipment on proper mounting and supports, connects refrigerant lines with nitrogen-purged brazing, wires all components to code, installs the thermostat, modifies ductwork as needed, and cleans up completely.
KIC Refrigeration commissions every HVAC installation in San Antonio, TX with a documented startup procedure. We record all operating pressures, temperatures, airflow readings, and gas manifold pressures on a commissioning form. We register the warranty, explain seasonal maintenance, and provide a complete documentation package.
Common questions about hvac installation costs, timelines, and what to expect.
Complete HVAC installation in San Antonio ranges from $7,000 to $15,000 for a mid-efficiency furnace and AC combination — typically an 80 percent AFUE furnace paired with a 14.3 to 16 SEER2 condenser. High-efficiency systems with variable-speed blowers and two-stage or variable-speed compressors run $12,000 to $22,000 but deliver significantly lower operating costs and qualify for federal tax credits. Heat pump systems fall between $5,000 and $18,000 depending on whether the system is single-stage, variable-speed, or a dual-fuel configuration. Ductwork modifications or new duct runs add $1,000 to $5,000. KIC Refrigeration provides detailed written proposals for San Antonio homeowners with every cost itemized and no hidden fees.
Correct HVAC system sizing is determined by a Manual J residential load calculation — the ACCA industry standard — that accounts for your home square footage, ceiling height, insulation R-values, window area and U-factor, air infiltration rate, duct losses, occupancy, and the local TX winter and summer design temperatures. As a rough reference, a well-insulated 2,000-square-foot home in San Antonio typically needs a 2.5 to 3.5 ton system, while a poorly insulated home of the same size may need 4 tons. KIC Refrigeration never estimates by rule of thumb — we run a proper calculation for your specific San Antonio home to avoid oversizing, which causes short cycling, high humidity, and premature compressor wear.
A properly installed and maintained HVAC system in San Antonio typically lasts 15 to 20 years for the gas furnace and 12 to 18 years for the air conditioner or heat pump outdoor unit. Variable-speed equipment tends to last on the higher end of these ranges because it runs at reduced capacity most of the time, causing less thermal and mechanical stress on components. The three biggest factors in equipment lifespan are installation quality, annual professional maintenance, and regular filter changes every 1 to 3 months. KIC Refrigeration offers maintenance plans for San Antonio homeowners that include seasonal tune-ups, priority scheduling, and repair discounts to help you get the maximum life from your investment.
Yes, substantially. Replacing a 10 SEER air conditioner with a 16 SEER2 unit reduces cooling energy consumption by approximately 38 percent. Upgrading from an 80 AFUE furnace to a 96 AFUE condensing furnace saves 16 cents of every heating dollar — the old furnace sends 20 cents up the flue while the new one captures it. Combined with proper installation practices — correct refrigerant charge verified by superheat and subcooling, proper static pressure and airflow at 400 CFM per ton, sealed duct connections, and a programmable thermostat — a new system typically saves San Antonio homeowners $600 to $1,800 per year depending on home size, usage patterns, and local energy rates.
What our customers say about working with our HVAC team.
"Air duct cleaning was good. They used a camera to show me before and after which I appreciated. The crew was respectful and wore shoe covers inside."
"KIC Refrigeration has serviced our commercial HVAC system for two years now. Always professional, always on time. Would not trust anyone else."
"AC repair was fast and fairly priced. The compressor was failing and they had the part on the truck. Done in about ninety minutes."